First gen DOHC head porting

The Engine Performance Board is for detailed discussions of all mechanical aspects of engine performance, including intake and
exhaust, cam and crankshaft, and all other technical aspects of the Neon powerplant. Please refer all general maintenance and repair questions to the General Forums above.
Post Reply
DanF86
Neon Enthusiast
Posts: 42
Joined: Fri Aug 17, 2012 6:43 pm
Location: Lansdale, PA

First gen DOHC head porting

Post by DanF86 » Mon Jul 13, 2020 5:16 pm

I'm in the process of porting out a DOHC head, I remeber reading somewhere not to mess with the hump on the exhaust side near the manifold, other than light blending and flash cast cleaning. Is that right or am I remembering wrong?

I thought the write up was from here but can't seem to find it
97 dohc mtx, iceman, half shaft atx tb, p&p intake, mpp ecu, tti header, cat delete, tru bendz 2.5" header back, vibrant muffler, semi solid bobble, prothane inserts, boogers, ps delete.

Post Reply

Return to “Engine Performance”

Who is online

Users browsing this forum: No registered users and 2 guests